Xspot Solution enables A/V integrators to quickly and precisely locate pre-wire termination points after sheetrock is in place.

Simply secure your wire with the Xspot or Xspot mini, snap into the Xstrap or Xbox and attach to your precise location on any framing member. The sheetrock or other surface material (up to 1” thick) is hung covering the Xspot location. Utilize the Xtreme locator to quickly establish the Xspot location and mark an “X” to note the exact spot to drill using the Xcentric which centers on the Xspot within ¼ of an inch!

The Xspot Solution will dramatically reduce pre-wire labor by as much as 50% by eliminating far less accurate devices such as wire toners and stud finders, while providing installers with the reassurance that their wires will be protected and secure right where you left them. In addition the Xspot™ has been made to be re-used over and over again bringing down the cost of the product each time you use it!

Xspot is also the first ever locating system that works without any wiring present whatsoever. Installers can run 1-inch conduit into the Xbox and mount an Xspot at each termination point—nothing more is required before sheet-rocking! Installers can now skip the costly “extra step” of driving back to the project after the sheet rockers have finished, just to place plugs or wall plates over wire holes. The Xspot system enables installers to quickly locate termination points through the wallboard and access their wiring at any time making the wire “Out of Sight but not Out of Reach”.

Xspot products combine to create a precision tool that saves both Integrators and builders substantial time and money. There are six modular components within the Xspot™ Solution (patents pending) that provide this invaluable Solution for the A/V and Low Voltage industries.

www.xspotroducts.com